Remote controlled motorcontroller - 12V / 24V

Remote controlled motorcontroller ready for connecting a motor. The controller makes it possible to control the direction - back, forth and stop with the supplied remotecontrol. It is especially practical for actuators.

Functions

There is a jumper inside the relay, that can be placed in three ways. It is the placement of this jumper that decides in what way the relay operates. 

A: left (Momentary-function):
You will typically only use the momentary. With the momentary the motor will only run while you push a button down on the remote. 

B: middle (Latch-function): 
With the latch-function the motor will run in one or the other direction, and you will be able to turn it off again on the stop-button.

C: right (Periodic-function):
with the periodic the motor will run in one or the other direction and will turn off itself after about 1 second. 

Connecting

Red wire: Plus

Black wire: Minus

Blue and brown wires: Motor supplement

If the motor runs opposite of what you expect, swap the blue and brown wire.

Learn-button

The learn-button is used to register the buttons on the remote in the controller. 

To register a button to each of the three functions - up, down and stop - you will have to push the learn button 1,2 or 3 times, before pushing the equivalent button on the remote.

When a code is received, the conttroller will flash three times.

To reset the controller, simply push and hold the learn button until the LED flashes.