Prostrobe Lift

Prostrobe Lift LED lamp that, with its very flat and slim design, is perfectly suited for all kinds of lifts or other surfaces where there is no space for bigger strobe-lights, nor should sight much. 

The warning light has 6 different patterns. The lamps remembers the pattern, so that you do not have to do a new setup each time.Prostrobe Lift is R6, ECER10 and ECER148 approved.

Connection

The strobe and warning light is connected like shown below:

Red = Plus warning light  (12V-36V)
Black = Minus / Ground
Yellow = Flash pattern
White = Synchronization
Gray = Signal for constant light by wiring to red / plus

Flash-pattern

When you pulse the yellow wire to plus under 1 second the lamp changes to the next flash pattern. If you hold it in for 1-3 seconds it will go back to the previous pattern. If you hold it in for more than 5 seconds it will turn off.

Grouping

When you connect both red and yellow to plus at the same time, the grouping setup is started. The lamp with then flashes once or twice to show the setup grouping. You can change the group by pulsing the yellow wire to plus. As soon as you turn off the lamp, it will remember set grouping