4040 Profile system for construction
Series of large strong profiles and accessories that fit together. All parts has a 8mm slot / track that fits together.
Products in the category
Standard profiles in 4040, with basis dimensions 40 x 40mm and 8mm slot. The profiles are an extra thick model.
Extra strong double-width series 40 profile with 8mm slot, that can be used as a basis frame in a larger constructon.
Alu profile in series 40, with 16mm height and one 8mm slot. Can be used for lids and other purposes, that only require one track.
Extra strong alu profile that is 80mm wide, 20mm tall. Can be used as a table / base plate.
Smart corner-joint that is used for screwing two or three profiles together in a corner, eg. in a box. Covers for the holes included.
A bracket for connecting to profiles of 90 degrees. It is made of a solid aluminum.
Extra large brackets in cast aluminium that gives you extra stiffness compared to standard bracket. Mounted with 4 bolts.
Strong bracket for mounting a supporting profile in a corner. The triangle joint will give you maximum stiffness between two profiles.
Flat brackets in painted metal for outside joints of profiles. L and T-brackets available.
Solid brackets in aluminium that are angeled on 45 and 135 degress. Used for triangles and octagons.
A strong aluminium-bar that fits in to series 40, 8mm slots. 4 large bolts tightens the two profiles securely together.
An inside-bracket for joining two profiles in a 90 degree angle.
Metal piece that prevents that a profile fastened with a bolt in the end, can be twitsted loose.
Block with a nute, that fits in series 40 profiles. Allows you to eg. bolt a plate or similar to the profile.
Bracket for fastening a series 40 profile to floor or wall. The bracket is bolted on to the profile and the surface.
Wheel in hard plastic, that fits in to series 30 and 40 tracks (8mm). Can be used for securely guiding movable parts.
Plastic and aluminum hinges, that can be used for doors and lids
Simple mechanism for holding doors and similar closed. The two small balls will clamp around the other part. A good pull unlocks it.
Tiltable arm in aluminium that can be mounted between two profiles.
Plastic-base that fits in series 30 and 40 profiles. A carabiner for hanging up items is included.
A nut that is pushed in to the end of a 40-series profile, where after it can be pushed in place. M3, M4, M5, M6 or M8 thread.
Nut that fits in to series-40 profiles, where after you can put in a bolt. This nut turns itself in to position when tightened,
T-nut that can be pushed in to the tracks on series 40 profiles. The spring avoids it gliding and falling out again.
A hammer-bolt with M8 thread that fits in to Series 40 profiles. Used for easy mounting to the profile.
Wheel with or without lock-pedal. Can be used for movable tables and other objects that should be easy to move.
Strong plate that is bolted on to the end of 4080 profilesm where there is M12 thread in the middle, eg. for legs and wheels.
Strong and wide tiltable foot with threaded rod, with M8, M10 or M12 thread. Intended for system profiles, but is universal
End-caps for Series 40 profiles. Simply pushed in to the end of the profiles, where after the sharp edges are covered.
Cover for closing the tracks in series 30 and 40 profiles. Give a nice finish and avoids dust and dirt in the tracks.
A plastic profile / seal that fits in series 30 and 40 profiles. It can hold a 5mm plate inside the slot.
Cover strip with 10mm brushes, that fit series 30 and 40 tracks. Can be used for tightening, clean, guide and fix.
Holder for cable ties, that fit down in to series 40 tracks. Makes it easy to fasten loose cables, hoses etc.